Oracle-audio-technologies Sun Oracle SunDual 10GbE XFP Manuale Utente Scaricare il pdf (Pagina 30)

20 Sun Dual 10GbE XFP PCI Express Card User’s Guide • May 2010

7. Connect the Ethernet cables.

Verifying the Hardware Installation

After you have installed the Sun 10-Gigabit Ethernet adapter, but before you boot

your system, perform the following tasks to verify the installation. Refer to the your

Solaris documentation for the detailed instructions.

Note – Verification is not required if your system supports dynamic reconfiguration

(DR). Verification is not supported if your system is running Solaris x86 software.

▼ To Verify the Hardware Installation

1. Power on the system, and when the banner appears, press the Stop-A key

sequence to interrupt the boot process and display the OpenBoot (ok) prompt.

2. List the network devices on your system.

Checking the .properties output for each device is the surest way to identify

the device. Usually /pci@7c0/pci@0/pci@8 or /pci@7c0/pci@0/pci@9

correspond to PCIe slots, so look at those devices first.

Note – If you do not see the device listed, check that the adapter is properly seated.

If necessary, reinstall the adapter.

ok show-nets

a) /pci@7c0/pci@0/pci@8/network@0,1

b) /pci@7c0/pci@0/pci@8/network@0

c) /pci@7c0/pci@0/pci@2/network@0,1

d) /pci@7c0/pci@0/pci@2/network@0

e) /pci@780/pci@0/pci@1/network@0,1

f) /pci@780/pci@0/pci@1/network@0

q) NO SELECTION from the above list

a) /pci@7c0/pci@0/pci@8/network@0,1

b) /pci@7c0/pci@0/pci@8/network@0

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 85 86

Nessun commento

Oracle-audio-technologies Sun Oracle SunDual 10GbE XFP Manuale Utente Pagina 30